Problem ID:
|
420
|
Start Date:
|
6/1/2005 12:50:00 PM
|
Close Date:
|
7/7/2009 11:47:16 AM
|
Category:
|
General/Other
|
|
When i try to access the software I get a couple different error messages.
#1. An internal error has been encountered Location:Setup Error:429 Text: Active x component can't create object
#2 Location:Convertdata20 Error: 91 Text: Object Variable or with block variable not set
I have tried uninstalling the software and reinstalling and get the same errors.
|
Please try the following steps in order. After each step try the program again, because any of these may fix this error.
1. Run this link from our website: http://www.allprosoftware.com/technicalsupport/SupportFiles/fix713.bat then re-install the software.
2. Run this link from our website: http://www.allprosoftware.com/technicalsupport/SupportFiles/jet40sp3_comp.exe
3. Run this link from our website: http://www.allprosoftware.com/technicalsupport/SupportFiles/msxml3.msi
4. Run this link from our website: http://www.allprosoftware.com/technicalsupport/SupportFiles/windowsscript.exe
|